preston on Is this Proof that Derren Brown’s Apocalypse was Staged and Fake? Is Steve Brosnan an Actor.I hope I have some success, I could do without having to buy a new printer.Īnyway, I hope at least the above info may help someone else. Next I’m going to test the switch itself with a multimeter, and also the cables from the switch. Nothing seems obviously out of place, or obstructed. Had a good look around the purge mechanism. This led me to think that the switch itself was at fault or the ink purge tubes might be clogged.ĭisassembled printer again. Seemed to communicate with printer but hasn’t got rid of the error message. Put printer into service mode and ran the service tool app. Still the same error when printer reassembled and powered up. Mopped up excess gunky ink from the purge nozzle and directly under the nozzle. I took out my absorber pads and washed/dried/re-inserted them in case that was part of the problem a messy, inky, water and kitchen roll consuming job. Īnd here’s a video of where the valve cam sensor is located for another canon printer, but similar to the ip4600. Here’s a (non English) video of disassembly which goes a little further than the service manual. I’ve done a lot of googling and youtube vid searching to find detailed disassembly instructions (necessary to get to the absorber pads underneath) and also details on the cam valve sensor. Unfortunately I haven’t been able to get rid of my pesky error 6c10 which after a look at the service manual is “The valve cam sensor was faulty at power-on or when purging was attempted.” I cannot be held responsible if you render your printer unusable. If you use this software on your own printer then you do so at your own risk. You should now be able to print again! Regards, Grumpy Gitĭisclaimer: This software is provided “as is”. Now, I am not 100% what everything does in this software but you should be able to reset the waste ink pad counter. Please leave a comment if you download 🙂 Release the Power Buttonīy this time your printer is in service mode already. Reset can be done once your printer is on Service Mode: a. You will need to put your printer into service mode (see below)Īssuming that your printer (ip4600 series) is already installed on your PC. The normal fix for this problem is to take it to a service centre where they use the same software and replace the waste ink pad at a cost! Normally, it’s cheaper to go out and buy a new printer!ĭownload now: DOWNLOAD Canon IP4600 Service Tool NEW: DOWNLOAD Canon IP4600 Service Tool MANUAL The software can reset your Waste Ink Pad Counter if you cannot print. I have tracked it down and made it available to download here. If you have found this page then like me, you had a hard time finding the Canon IP4600 service tool.

Download canon pixma service tool